FORGOTTEN-QUERY RESOLUTION
Can a 10-inch miter saw
cut a 4×4?
Often yes at 90°, but not because every 10-inch saw has identical capacity. The exact model must clear approximately 3.5 inches in both dimensions, and angled cuts may reduce the usable envelope.
DIRECT ANSWERCheck the model—not the blade label.
- A nominal 4×4 is commonly about 3.5″ × 3.5″.
- Published 90° capacity can support a verified answer; compound cuts need additional clearance checks.
- Never rotate unstable stock or defeat a guard just to complete the cut.
Featured 10-inch model records
| Model | Published 90° envelope | 4×4 screening result | Verify |
|---|---|---|---|
| Makita LS1019L | 3.625″ high × 12″ wide | Inside normalized 90° envelope | Manufacturer source ↗ |
| Milwaukee 2734-21HD | 3.59″ high × 11.39″ wide | Inside normalized 90° envelope | Manufacturer source ↗ |
| Bosch CM10GD | 3.5″ high × 12″ wide | Inside normalized 90° envelope | Manufacturer source ↗ |
This is a capacity-screening conclusion, not a hands-on observation. Model revision, fence geometry, blade guard, clamps, workpiece defects, and actual dimensions remain physical verification gates.
WHEN THE ANSWER CHANGES
Miter and bevel angles consume capacity.
A saw that clears a square 90° crosscut may not clear the same stock at 45° miter or with the head beveled. The limiting dimension and interference points change.
WHAT THIS IS NOT
Blade diameter is not a universal promise.
Two 10-inch saws can have different fence heights, pivots, rails, guards, and published cut charts. “10-inch” describes the blade class—not the complete cut envelope.